Mounting The Cat Mod – Double Decker

It’s important to read our basic mounting instructions before continuing on. The basic mounting instructions will help you determine what tools you will need and also about how to mount individual planks, sisal poles, and Escape Hatches.

This is a really fun layout. You will need three studs spaced out at 16″ from center to center. Start by marking the center of each of the three studs you’re using.

The Cat Mod – Double Decker comes with a single piece of fabric 64″ long.

We suggest mounting the first level up the wall 14-20″ off of the ground.

Mount your first plank into your far right stud.

Attach the 64″ piece of fabric to the mounted plank and then use furniture screws to attach the wooden top to firmly hold fabric into place.

Attach a plank to the fourth set of grommets away from the shelf, stretch the fabric straight to the left, and mark the corner of the plank. Mount that plank with the two holes that best line up with the stud.

Place the second set of grommets from the plank you just mounted over the mounting posts on another plank. Stretch the fabric straight up, mark the corner, and then mount the plank.

It’s easiest to use the level included to hold along the fabric to make sure it’s perfectly vertical, and that it goes into the same stud.

Attach another plank to the last set of grommets, stretch the fabric straight to the right, and mark the corner of the plank. Mount that plank with the two holes that best line up with the stud.

Leave a Reply

Your email address will not be published. Required fields are marked *